Skip to main content

kitchenremodelingmillcreek.com

Home › Cost calculators › Kitchen Island Cost Calculator

Planning estimate · Millcreek, UT

Kitchen island cost calculator

An island is a small building with services in it. The cabinetry and the countertop are the visible half and roughly the cheaper half — the rest is getting power, and often water and waste, to a box in the middle of a room that was never designed to have one.

Your estimate

What is behind the number

This is a planning estimate, not a contractor quote. It is built from the cost ranges published elsewhere on this site, from Millcreek’s own published permit rules, and from current Salt Lake Valley kitchen cost data. It cannot see whether your walls are square, what is under the old floor, whether the panel has room for another circuit, or whether the wall you want to open is carrying the roof — and those are the things a real price turns on. A firm number comes from someone standing in the room with a tape measure.
What drives the price

Clearance first, then services, then the nice part

Before anything else: an island wants roughly 42 inches of clear walkway on every side, and closer to 48 on the side people work from. Millcreek's post-war kitchens are frequently exactly the size where an island stops the room working rather than improving it. Mark it out in tape on the floor and walk around it before you price anything — a peninsula attached to one run gives most of the same benefit and needs clearance on two sides instead of four.

Then the services, because they are what separate the site's published ranges. An island with cabinets and a countertop and nothing else is one number. An island with a sink is nearly three times it, because the drain has to reach the middle of the room with fall. Where it runs matters enormously: through a basement ceiling is straightforward, through a crawl space is slower, and through a concrete slab means trenching, connecting, backfilling and making the floor good again.

And one small thing with a large consequence. An island of any real size is expected to have a receptacle, and countertop receptacles have to be GFCI protected. That single outlet is what takes the job out of Millcreek's finish-work exemption and into permitted, inspected work — which is worth building into the programme rather than discovering in week two.

Clearance, before anything else

42 inches all round is the working minimum. In a kitchen under about 150 square feet a fixed island usually does not fit, whatever the budget says.

What services it needs

Power alone is a modest line that changes the permit position. A sink adds drain, supply and vent. A cooktop adds a circuit and then an extraction problem.

What is under the floor

A basement is easiest, a crawl space is slower, a slab means cutting concrete. This is the single largest variable on a plumbed island.

Length

The cabinetry, the countertop and the seating all scale with it. Six feet is the common size and it is common for good reasons.

Seating and overhang

Anything past about ten inches of unsupported stone needs brackets or corbels underneath. A raised bar level means two heights and usually two materials.

The countertop

The island is normally the piece people choose the best material for, because it is the surface everyone looks at.

What pushes it higher

  • A sink or a dishwasher, which needs drain, supply and vent run to the middle of the room.
  • A concrete slab under the kitchen, which means trenching the drain into concrete.
  • A cooktop, and then extraction, which has no easy answer in an island.
  • Waterfall ends, which are the most slab fabrication available.
  • A wrap-around or raised bar level, which is two heights and usually two materials.
  • A pre-1960 house, where the drain is often cast iron in a tight crawl space.

What brings it down

  • No services at all, which keeps the island inside Millcreek's finish-work exemption.
  • A peninsula attached to an existing run instead of a free-standing island.
  • Putting the sink in the perimeter run and keeping the island as work surface.
  • A basement or crawl space rather than a slab, where the layout gives you the choice.
  • A shorter island — cabinetry, countertop and seating all scale with length.
  • Butcher block on the island rather than matching the perimeter stone.
Somewhere to start

Turn the estimate into a real number

Send a couple of photos of the kitchen, rough dimensions, and say roughly when the house was built. You will get a straight answer about what the layout, the panel and the plumbing will allow before anyone talks about finishes.

Questions

What people ask about this

How much does a kitchen island cost in Millcreek?

This site publishes $1,500 to $4,000 for a compact or mobile island, $3,500 to $9,000 for a basic fixed island with cabinets and a countertop, $4,500 to $11,000 with a seating overhang, and $6,000 to $16,000 or more once it has a sink or an appliance. Island electrical on its own runs $500 to $2,000.

How much space do I need for an island?

Around 42 inches of clear walkway on every side, and 48 on the working side. That usually means a kitchen of at least 150 square feet before a fixed island makes sense, and more for a longer one. Tape it out on the floor first — it is the single most useful ten minutes in this whole decision.

Do I need a permit for a kitchen island?

If it has no services, no — cabinets and countertops are named in Millcreek's exemption list. Add a receptacle, which an island of any real size is expected to have, and you are into permitted work. A sink adds plumbing permits on top.

Can I put a sink in the island?

Yes, and it is a popular choice because it puts the person washing up facing into the room. The cost depends almost entirely on what is under the floor: a basement or crawl space makes it straightforward, a concrete slab means trenching the drain into the concrete and making the floor good afterwards.

What about a cooktop in the island?

It works, but extraction is the hard part. With no wall behind it the options are a ceiling-mounted hood ducted up through the floor above and out through the roof, or a downdraft that rises out of the counter. The first is effective and involves working in the room above. The second is tidier and less effective. Decide before the island is built, not after.

How big should the overhang be for seating?

Twelve inches is comfortable for casual seating and fifteen is better for a proper meal. Anything past about ten inches of unsupported stone needs brackets or corbels underneath, which is a real line rather than a detail.

Is a peninsula a good alternative?

Often a better one in a Millcreek post-war kitchen. It gives you the extra work surface and the seating, it needs clearance on two sides instead of four, and running services to it is much easier because it connects to an existing run.

Should the island match the rest of the kitchen?

There is no rule, and a contrasting island is one of the few design decisions that costs nothing extra. A different cabinet colour or a different countertop material on the island is a common and effective choice — and butcher block on the island with stone on the perimeter is both cheaper and genuinely useful.